Venipuncture (Evacuated Tube System) — Practice Checklist

Step-by-Step Procedure (16 steps)

1. 1.

   Review the requisition/order and verify it matches the patient.

2. 2.

   Gather supplies: needle, holder, correct tubes in order-of-draw sequence, alcohol prep pads, gauze, bandage, sharps container.

3. 3.

   Perform hand hygiene and don gloves.

4. 4.

   Identify the patient using two identifiers (full name and date of birth) and confirm against the requisition.

5. 5.

   Explain the procedure and obtain verbal consent.

6. 6.

   Position the patient's arm, extended and supported, slightly bent downward.

7. 7.

   Apply the tourniquet 3–4 inches above the intended site; ask the patient to make a fist (not pump it).

8. 8.

   Palpate and select a vein, noting direction and depth.

9. 9.

   Cleanse the site with 70% isopropyl alcohol in a circular motion from the center outward; allow it to air dry completely.

10. 10.

    Anchor the vein by pulling the skin taut below the site.

11. 11.

    Insert the needle at a 15–30 degree angle, bevel up, in the direction of the vein.

12. 12.

    Advance the first tube onto the needle and allow it to fill; release the tourniquet once blood flow is established (within 1 minute of application).

13. 13.

    Fill remaining tubes in the correct order of draw, gently inverting each tube immediately after removal per its additive requirement.

14. 14.

    Withdraw the needle, activate the safety shield, and apply pressure with gauze immediately.

15. 15.

    Label every tube at the bedside, in the patient's presence, before leaving the room.

16. 16.

    Dispose of the needle directly into the sharps container; apply a bandage once bleeding has stopped.

Instructor Competency Checkpoints (6)

Your instructor or preceptor will be watching for all of these during sign-off.

• Correctly identifies the patient with two identifiers before any supplies are opened.

• Tourniquet is released within 1 minute of application.

• Tubes are filled and inverted in the correct order of draw.

• Needle is disposed of directly into a sharps container with no intermediate setdown.

• Every tube is labeled at the bedside before leaving the patient.

• Site is checked for bleeding before a bandage is applied.

Critical Mistakes — Avoid These

• ⚠

  Leaving the tourniquet on for more than 1 minute, which raises hemolysis risk and can skew potassium, chemistry, and CBC values.

• ⚠

  Having the patient pump their fist, which can falsely elevate potassium and other analyte levels.

• ⚠

  Mislabeling a tube or labeling it away from the patient's bedside.

• ⚠

  Drawing tubes out of order, which can carry additive from one tube into the next and invalidate results.

• ⚠

  Probing for a vein instead of withdrawing and reassessing — probing increases hematoma risk and patient discomfort.

• ⚠

  Setting the used needle down anywhere other than directly into the sharps container.